Research Information System
Metals, vol.16, no.2, 2026 (SCI-Expanded, Scopus)
In the present study, the effects of electrode geometry and welding current on the tensile-shear strength, failure energy, fracture type, and joint microstructure were investigated during the RSW of ultra-high-strength MS1500 steel to high-strength low-alloy SPFC590 steel, both 1.2 mm in thickness. Three electrode geometries—designated as G0-6 mm, G0-8 mm, and A0—recommended for 1.2 mm sheets according to ISO 5821 were examined. It was found that in the G0-6 mm electrode geometry, which has the smallest contact area, excessive expulsion occurred at lower current levels compared to the other geometries. Consequently, this configuration resulted in lower maximum tensile-shear strength and failure energy values. The highest mechanical performance was achieved with the G0-8 mm electrode geometry, where the tensile-shear strength and failure energy were measured as 19.42 kN and 43.81 J, respectively. For the A0 electrode, although the maximum tensile-shear strength (19.68 kN) was comparable to that of the G0-8 mm geometry, the failure energy was approximately 7% lower (40.94 J). For all electrode geometries corresponding to maximum mechanical strength, a pull-out failure mode was observed, where the nugget region of the SPFC590 steel detached from the base metal and remained adhered to the ultra-high-strength MS1500 sheet.