Surface characterization and radical decay studies of oxygen plasma-treated PMMA films


Ozgen O., Aksoy E. A., Hasirci V., HASIRCI N.

SURFACE AND INTERFACE ANALYSIS, vol.45, no.4, pp.844-853, 2013 (SCI-Expanded) identifier identifier

  • Publication Type: Article / Article
  • Volume: 45 Issue: 4
  • Publication Date: 2013
  • Doi Number: 10.1002/sia.5181
  • Journal Name: SURFACE AND INTERFACE ANALYSIS
  • Journal Indexes: Science Citation Index Expanded (SCI-EXPANDED), Scopus
  • Page Numbers: pp.844-853
  • Keywords: PMMA, oxygen plasma treatment, contact angle, SFE, XPS, ESR, CONTACT-ANGLE MEASUREMENTS, POLY(METHYL METHACRYLATE), GLOW-DISCHARGE, NANOPATTERNED POLYMERS, FRICTION PROPERTIES, FREE-ENERGY, ADHESION, PRESSURE, FIBERS, SIMS
  • Hacettepe University Affiliated: Yes

Abstract

Polymethylmethacrylate (PMMA) films were modified by RF oxygen plasma with various powers applied for different periods, and the effects of these parameters on the surface properties such as hydrophilicity, surface free energy (SFE), chemistry, and topography were investigated by water contact angle, goniometer, X-ray photoelectron spectroscopy (XPS), and atomic force microscopy, and the types of the created free radicals and their decay were detected by electron spin resonance spectroscopy (ESR). SFE and contact angle results varied depending on the plasma parameters. Oxygen plasma treatment (100 W-30 min) enhanced the hydrophilicity of PMMA surface as shown by decreasing the water contact angle from 70 degrees to 26 degrees. XPS analysis showed the change in the amounts of the present functionalities as well as formation of new groups as free carbonyl and carbonate groups. The roughness of the surface increased considerably from similar to 2 nm to similar to 75 nm after 100 W-30 min oxygen plasma treatment. ESR analysis indicated the introduction of peroxy radicals by oxygen plasma treatment, and the intensity of the radicals increased with increasing the applied power. Significant decrease in radical concentration was observed especially for the samples treated with higher powers when the samples were kept under the atmospheric conditions. As a conclusion, RF plasma, causes changes in the chemical and physical properties of the materials depending on the applied parameters, and can be used for the creation of specific groups or radicals to link or immobilize active molecules onto the surface of a material. Copyright (C) 2012 John Wiley & Sons, Ltd.